ioprentals.blogg.se -

2.5 Measuring Workpieces with a 3-D Touch Probe.

Setting datum points using holes/cylindrical studs.

2.4 Setting the Datum with a 3-D Touch Probe.

Saving the basic rotation in the preset table.

Managing more than one block of calibrating data.

Calibrating the effective radius and compensating center misalignment.

Writing the measured values from touch probe cycles in the preset table.

Writing the measured values from touch probe cycles in datum tables.

Recording measured values from the touch probe cycles.

Touch trigger probe, rapid traverse for positioning: MP6151.

Touch trigger probe, rapid traverse for positioning: MP6150.

Touch trigger probe, probing feed rate: MP6120.

Confidence interval for multiple measurement: MP6171.

Consider a basic rotation in the Manual Operation mode: MP6166.

Orient the infrared touch probe to the programmed probe direction: MP6165.

Safety clearance to touch point: MP6140.

Maximum traverse to touch point: MP6130.

1.2 Before You Start Working with Touch Probe Cycles.

Touch probe cycles for automatic operation.

Touch probe cycles in the Manual and Electronic Handwheel modes.

1.1 General Information on Touch Probe Cycles.

Functions changed since the predecessor versions 340 422-xx and 340 423-xx.

Feature content level (upgrade functions).